EN 14303:2009+A1:2013 工厂制矿物棉(MW)产品CE认证详解-上海郜盟

工厂制矿物棉(MW)产品ce认证标准

EN 14303:2009+A1:2013

Thermal insulation products for building equipment and industrial installations - Factory made mineral wool (MW) products - Specification

建筑设备和工业装置用隔热产品.工厂制矿物棉(MW)产品.规范

This European Standard specifies the requirements for factory made mineral wool products, which are used for the thermal insulation of building equipment and industrial installations with an operating temperature range of approximately 0 °C to + 800 °C.

本欧洲标准规定了工厂生产的矿物纤维制品的各项要求，这些制品用于建筑设备及工业设施的保温隔热，其工作温度范围大致为0°C至+800°C。

NOTE Below an operating temperature of ambient, special means against water vapour diffusion and water accumulation by air flow might be required. Below an operating temperaure of 50 C, special tests regarding the suitability of the products in the intended application are advised (e.g. liquefaction of oxygen). Manufacturer's advice should be heeded in all cases.

备注:在低于环境温度的操作条件下，可能需要采取特殊措施来防止水蒸气扩散和因气流作用而导致的积水现象。在低于50°C的操作温度下，建议进行专门测试以评估产品在预期应用中的适用性(例如氧气液化)。在任何情况下都应重视制造商提供的建议。

The products are manufactured with or without facings or coatings, in the form of rolls, boards, slabs, mats, felts, quilts, wired mats, lamella mats, bevelled lags and pipe sections.

产品可带或不带面层或涂层，以卷材、板材、板条、垫子、毡、绗缝垫、有线垫、片状垫、斜切膨胀管和管道段等形式制造。

This European Standard describes product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling

本欧洲标准描述了产品特性，并包括测试、符合性评估、标记和标签程序。

Products covered by this standard are also used in prefabricated thermal insulation systems and composite panels:the performance of systems incorporating these products is not covered.

本标准涵盖的产品也用于预制保温系统和复合板;但不包括包含这些产品的系统的性能要求。

This European Standard does not specify the required level of a given property that shall be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application can be found in regulations and invitations to tender.

本欧洲标准并未具体规定某一特定属性所应达到的所需水平，该水平须由产品实现，以证明其在特定应用场合中的适用性。特定应用场合所需的各项标准可在相关法规及招标邀请文件中找到。

Products with a declared thermal conductivity greater than 0,065 W/(mK) at 10 °C are not covered by this standard.

在10°C下，若产品声明的热导率大于0.065W/(m·K)，则不适用于本标准。

This Eurpean Standard does not cover products for in situ insulation (blowing or pouring) or products for the insulation of the building structure.

本欧洲标准不适用于现场保温(吹填或浇注)产品，也不适用于建筑结构的保温产品。

This European Standard does not cover the following acoustical aspects: direct airbore sound insulation and impact noise transmission index

本欧洲标准不涵盖以下声学方面:直接空气传播隔声和冲击噪声传输指数。

工厂制矿物棉(MW)产品ce认证法规

工厂制矿物棉(MW)产品产品出口欧盟需要满足CPR建材法规要求：

Regulation (EU) No 305/2011, Directive 89/106/EEC (CPD)【旧版】

工厂制矿物棉(MW)产品ce认证模式

有且仅有1个认证：模式 1，由欧盟公告机构进行测试和工厂审核后发证

制造商职责：	Factory production control (FPC)工厂生产控制;
	Further testing of samples taken at the factory工厂取样的进一步检验
Notified Body 公告机构职责：	Initial inspection of factory and FPC 工厂和FPC的初始检查;
	Continuous surveillance, assessment and approval of F.P.C. 持续监视、评估和批准F.P.C.