隔热矿物棉CE认证- EN 13162:2012+A1:2015详解-CPR

1、隔热矿物棉欧盟CE认证标准

EN 13162:2012+A1:2015 Thermal insulation products for buildings - Factory made mineral wool (MW) products - Specification 建筑隔热隔热矿物棉-工厂制造的矿棉（MW）隔热矿物棉-规范

2、隔热矿物棉欧盟CE认证法规

建材CPR Regulation (EU) No 305/2011

3、EN 13162:2012+A1:2015 适用CE认证隔热矿物棉范围

This European Standard specifies the requirements for factory made mineral wool products, with or without facings or coatings, which are used for the thermal insulation of buildings. The products are manufactured in the mat blankets, boards or slabs.

Products covered by this standard are also used in prefabricated thermal insulation systems and composite panels; the performance of systems incorporating these products is not covered.

This standard describes product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling.

This standard does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards.

Products with a declared thermal resistance lower than 0,25 m 2⋅K/W or a declared thermal conductivity greater than 0,060 W/(m⋅K) at 10 °C are not covered by this standard.

This standard does not cover in situ insulation products (covered by EN 14064 parts 1 and 2) and products intended to be used for the insulation of building equipment and industrial installations (covered by EN 14303).

本欧洲标准规定了用于建筑物隔热的工厂制造的矿棉产品的要求，包括或不包括饰面或涂层。产品采用毡、板或板制造。

本标准涵盖的产品也用于预制隔热系统和复合板；包含这些产品的系统的性能不包括在内。

本标准描述了产品特性，包括测试、一致性评估、标记和标签程序。

本标准未规定产品为证明其在特定应用中的适用性而需达到的给定性能的要求水平。给定应用程序所需的级别可在法规或非冲突标准中找到。

本标准不包括在10°C下宣称热阻低于0.25 m 2·K/W或宣称热导率大于0060 W/（m·K）的产品。

本标准不包括现场绝缘产品（EN 14064第1部分和第2部分涵盖）和拟用于建筑设备和工业装置绝缘的产品（EN 14303涵盖）。

4、隔热矿物棉欧盟CE认证模式

根据隔热矿物棉性能和使用环境要求，可采用如下认证模式申请CE

模式1：(A1, A2, B, C)^a

模式3：(A1, A2, B, C)^b , D, E

模式4：(A1 to E)^c , F

a Products/materials for which a clearly identifiable stage in the production process results in an improvement of the reaction to fire classification (e.g. an addition of fire retardants or a limiting of organic material).

b Products/materials not covered by footnote ( a ).

c Products/materials that do not require to be tested for reaction to fire (e.g. products/materials of classes A1 according to Commission Decision 96/603/EC, as amended).

5、隔热矿物棉欧盟CE认证测试项目

英文	中文
Thermal resistance and thermal conductivity	热阻和导热系数
Length and width	长度和宽度
Thickness	厚
Squareness	方形度
Flatness	平坦度
Reaction to fire of the product as placed on the market	对投放市场的产品着火的反应
Durability characteristics	耐久性特性
Dimensional stability	尺寸稳定性
Compressive stress or compressive strength	压缩应力或压缩强度
Tensile strength perpendicular to faces	垂直于表面的抗拉强度
Point load	点荷载
Compressive creep	压缩蠕变
Water absorption	吸水性
Water vapour transmission	水蒸气传输
Dynamic stiffness	动态刚度
Compressibility	压缩性
Sound absorption	吸声
Air flow resistivity	气流电阻率
Release of dangerous substances	危险物质的释放
Reaction to fire of the product in standardized assemblies simulating end-use applications	模拟最终用途的标准化组件中产品的火灾反应
Continuous glowing combustion	持续发光燃烧
Shear strength	抗剪强度
Bending strength	弯曲强度