上海郜盟为您专业解读潜水泵组件CE认证：

1、潜水泵组件CE认证指令

MD机械指令：2006/42/EC

2、潜水泵组件CE认证标准：

EN ISO 12100：2010 机械安全 - 用于设计的一般准则-风险评估及风险降低

EN 60204-1：2018机械安全.机械电气设备.第1部分：一般要求

EN 15268:2008 Petrol filling stations - Safety requirements for the construction

of submersible pump assemblies加油站.潜水泵组件结构的安全要求

3、EN 15268:2008适用范围：

This European Standard applies to submersible pump assemblies intended for use with dispensers installed at petrol filling stations and used to dispense liquid fuels in accordance with EN 228 and EN 590 into tanks of motor vehicles, light aircrafts, boats and portable containers. The submersible pump assemblies are intended for use and storage at ambient temperatures between –20 °C and +40 °C.

Additional measures can be required for use and storage at temperatures outside this range and are subject to negotiation between the manufacturer and purchaser.

This European Standard specifies requirements for equipment with a maximum working pressure not exceeding 350 kPa (3,5 bar), power consumption not exceeding 7 KW and a maximum power supply voltage of 500 V.

This European Standard specifies requirements for submersible pump assemblies of classes IIA T3(explosion group IIA and temperature class T3) and IIB T4 (explosion group IIB and temperature class T4) using liquid fuels.

This European Standard deals with all significant hazards, hazardous situations and events relevant to submersible pump assemblies, when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4).

This European Standard specifies safety requirements for design, installation, commissioning, use and maintenance.

Noise is not considered a significant hazard for the equipment in the scope of this European Standard.

This European Standard does not cover requirements for mobile equipment.

本欧洲标准适用于与安装在加油站的加油机一起使用的潜水泵组件，用于根据EN 228和EN 590将液体燃料分配到机动车辆、轻型飞机、船只和便携式集装箱的油箱中。潜水泵组件旨在在-20°C至+40°C的环境温度下使用和储存。

在超出此范围的温度下使用和储存可能需要采取额外措施，并由制造商和买方协商确定。

本欧洲标准规定了最大工作压力不超过350 kPa（3.5 bar）、功耗不超过7 KW、最大电源电压为500 V的设备要求。

本欧洲标准规定了使用液体燃料的IIA T3级（爆炸组别IIA和温度等级T3）和IIB T4级（爆炸类别IIB和温度等级T4）潜水泵组件的要求。

本欧洲标准涉及与潜水泵组件相关的所有重大危险、危险情况和事件，当它们按预期使用时，在制造商合理预见的误用条件下（见第4条）。

本欧洲标准规定了设计、安装、调试、使用和维护的安全要求。

在本欧洲标准范围内，噪声不被视为设备的重大危害。

本欧洲标准不包括移动设备的要求。